Purpose

This guide shows how to configure a Teltonika Automotive Router RUT850 or RUT955 to use it with Cloud4Wi.

Please note that the images contained in this article may contain outdated configuration data. You must check the data contained in the article "Parameters for the Solution" at the bottom of the page as they are certainly up to date.

Prerequisites

The configuration procedure has been performed and tested on a router model (RUT850) running Firmware version (R_03.00.330). Before integrating the router with Cloud4Wi, it is necessary that the access point is connected to the Internet through a SIM card (check the manual of the Automotive Router).

Logging in to the UI

To enter the router for the first time, please connect to the WiFi SSID called "rut850". Then type http://192.168.1.1 in your internet browser and use the credentials provided by Teltonika to log in.

01_UI_Login_page.png

Adding a new wireless network

After logged successfully, we need to add a SSID. On the main menu (Upper bar) click on Network → Wireless.

03_Network_wireless_tab.png

From Wireless Configuration page click Add.
04_Wireless_Conf_Add.png

Enter the name of your new SSID and click Save. In this example, we have called it "C4W-Teltonika".
05_0_WirelessName.png

Adding a new Hotspot on the SSID

To configure a new Hotspot, please click on Services Hotspot in the main menu toolbar.
05_1_Menu_Services_Hotspot.png

Click on the Edit button corresponding to the SSID previously created ("C4W-Teltonika").
06_Wireless_conf_edit.png

RADIUS Server data for the Authentication/Accounting Phase and Splash Portal

The firmware version RUT9XX_R_00.05.04 allows you to select "Cloud4Wi" as configuration profile, and skip the manual configuration of all the required fields.

teltonika-c4w-conf.png

Otherwise, configure here the parameters indicated in the paragraph below called "Parameters for the solution".

08_Hotspot_conf_page_2.png

Walled Garden

Please note that to allow the proper use of the Splash Page, you have to configure the domain "cloud4wi.com" on the walled garden section.
To enter a domain entry, please click the Add button, enter the domain name (e.g. "cloud4wi.com") and then click on Save.

09_Hotspot_Conf_page_3.png


To configure the walled garden for specific purposes, please check the following articles:

Parameters for the Solution

The following values are needed to integrate the device with the solution:

  • Enable: checked
  • Authentication mode: External radius
  • Authentication protocol: PAP
  • RADIUS server #1: 54.247.117.188 (Primary Server)
  • RADIUS server #2: 79.125.111.180 (Secondary Server)
  • Authentication port: 1812
  • Accounting port: 1813
  • Radius secret key: (Cloud4Wi will communicate it)
  • External landing page: checked
  • Landing page address: https://splashportal.cloud4wi.com/?vendor=teltonika
  • Walled Garden address: cloud4wi.com