Purpose
This article guides you through the creation and configuration of an Aruba Central network based on OS8 to support the Cloud4Wi Passpoint solution.
Create the SSID
- Navigate to Devices under the Manage section of your group.
- Click Config on the top right.
- Go to the WLANs tab and click + Add SSID.
General TAB
- On step 1 General, provide a name for the SSID and click Next
VLANs TAB
- On step 2 VLANs, configure according to your network and click Next
Security TAB
- On step 3 Security select Enterprise under Security Level
- Choose WPA2-Enterprise under Key Management
- Select the primary and secondary Radius server
Radius configuration
Create a new Radius Server with the following configuration:
IP Address Primary: 52.48.102.108
IP Address Primary Secondary: 34.252.97.217
Shared Key: it will be communicated by Cloud4Wi
Click on Advanced Settings
- Under Advanced Settings select the Passpoint Service Profile
- Click on Accounting and select Use Authentication Servers
Then click Next
- Under Passpoint Service Profiles click + Add Profile
Give a name to the Profile then click Access Network
- In the Domain Name write the same configured in the Cloud4Wi dashboardEnable Internet
As Operator Friendly Name write the same configured in the Cloud4Wi dashboard
- Under NAI Realms click +Add
- In Realm Name write the domain name configured in the Cloud4Wi dashboard
- As EAP Method select eap-ttls
- As Authentication param select ID: non-eap-inner-auth and Value: mschapv2
Click OK
OpenRoaming (if necessary)
To also enable OpenRoaming
- in the Roaming Consortium OI 1 write “5A03BA0000”.
- in the Roaming Consortium OI 2 write "004096".
- Click Save
Access TAB
- Select Unrestricted under Access rules
- Click Next